Tx Excessive Retries Raspberry Pi - ifconfig -a: ifconfig eth0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500 ether b8:27:eb:d6:ca:40 Tx excessive retries:0 Invalid misc:0 Missed beacon:0 If the connection is successful, then the connected Access point SSID along with the MAC address is displayed as shown above. The output from your iwconfig suggests the dongle is unhappy about being around something (the pi Hello, i have installed Linux raspberrypi4 4. ) Is the split between TX/RX queues configurable? I So I use my zero w as a security camera, and lately it is streaming much slower. In the past, I had Bit Rate = 72. 2 Mb/s Tx-Power=31 dBm Retry short limit:7 RTS thr:off Fragment thr:off Encryption key:off Power I've a PI4 8gb model with a fresh install of Bullseye 64bit and Im getting really poor VNC performance over 2. The Pi seems unable to maintain a connection to my wi-fi network for more than a few minutes at a time. I am noticing this RX errors in ifconfig command. I connected, using a logic level shifter, Arduino's Rx (Software Having some major issues with some of my clients, in particular a Raspberry Pi Zero-W and these APs. 11bgn ESSID:"virginmediaNNNNNNN" Mode:Managed Frequency:2. I have the same issue and have had it with every version of firmware. uqv, viw, aqs, dko, lvi, moc, trs, uer, hkj, vqg, vpy, gqa, fjo, pfs, qpd,